Your cart is empty.
Your cart is empty.Product Description
Fatty the fatster
Reviewed in the United States on January 31, 2025
nicer than expected
rick brescia
Reviewed in the United States on January 27, 2025
A good Pegboard holding tool
RickyPetite
Reviewed in the United States on August 14, 2024
My screwdrivers tilted forward (away from the pegboard) until I bent the top loops upward. After manual adjustment, I got the screwdrivers to sit correctly. Overpriced
Ted
Reviewed in the United States on June 16, 2024
I actually am using these to hang bungee cords off my peg board. I can hook them over the loops by size.
Fred J.
Reviewed in the United States on May 27, 2024
As described. Fast shipment. Very satisfied.
Hummingbirds
Reviewed in the United States on September 27, 2023
This is a great screwdriver holder. I have two of them on my pegboard and so glad I got this one. Since the ends are not completely closed, it was very easy to open them up with pliers a little so that they fit my screwdrivers exactly. Highly recommend the screwdriver rack!
Rolidnot
Reviewed in the United States on January 16, 2021
I use the "Wall Control" metal pegboard (see photo) and the screwdriver rack from Wall Control is junk. It pops loose all the time, the holes are small which causes slot screwdrivers to get stuck and pull that rack off the board. The Wall Control peg hooks are well made pieces of junk. I got sick of those and ordered these stainless wire racks. MUCH better and huge improvement in utility!These new wire screwdriver racks fit perfectly, hold tight to my pegboard, don't fall off when I remove a screwdriver like the Wall Control pegs and screwdriver holder and these new wire racks are gleaming stainless steel. They will accommodate most any size regular screwdriver and even some smaller nut drivers. I can even slide a few wood chisels and a putty knife behind the rack with no affect on utility.Nothing not to like about these simply but highly useful stainless screwdriver racks. Hope that helps!
Andrew C
Reviewed in the United States on April 20, 2021
The product does what it’s suppose to do but I don’t recommend using them on a metal pegboard. Because the metal pegboard is thin compared to regular pegboard the screwdriver holder leans forward causing screwdrivers not to sit good in it.
Recommended Products