Your cart is empty.
Your cart is empty. 【Package Included】
Package: 4PCS Material: C360 Brass Length: 12 inches
Feature:
1.Good material for DIY craft making
2.Brass Flat Bar stock is perfect for a variety of Craft , milling, lathe, knife hobby raw material & custom engraved plates.
3.The longer length is enough for you to cut at will
Customer
Reviewed in the United States on January 10, 2025
These bars had nicely eased edges, perfect symmetry (no bulges anywhere along the length). It made routing channels to inlay the brass into church prayer altars possible to produce perfect inset of the brass pieces cut to length. Whatever they were coated with was compatible with spray lacquer that I applied to control tarnish. So, I assume they were factory coated with lacquer.Having said that, they were not factory polished to the same degree as, say, granite finishers wet grind/polish granite slabs used for kitchen counters: meaning fine-ground to flatten the surfaces to a mirror finish. These bars had minute (mi-nute meaning very tiny) ridges across the width, but too small to see at 3 ft viewing distance and with 2 more coats of lacquer. So, perfect for my use.
Rafn Markelius
Reviewed in the United States on September 11, 2024
These bars were perfect for an inlaid detail in a wooden floor repair: consistent dimensions and easy to cut.
wc l.
Reviewed in the United States on June 27, 2024
priced right should work fine for me
Thomas Veach
Reviewed in the United States on May 26, 2024
I needed some stiffeners for a keyboard project and this is perfect. Easy to drill and tap.
amaz0n cust0mer
Reviewed in the United States on December 17, 2024
Its brass square rod of a certain size. No complaints.
gemlam
Reviewed in the United States on November 2, 2024
Not what I expected. Poor brass quality. Will return.
Scott Sullivan
Reviewed in the United States on July 7, 2023
Exactly what I expected.
Joseph A. Curtiss
Reviewed in the United States on February 26, 2022
I watched a U-Tube video on using brass bars for aligning routers and saws, so I ordered a set. They arrived quickly and appeared to be a quality product. I measured them with my micrometer, and sure enough they are EXACTLY 1/4 by 1/4 inch. Nice to have these and plan many uses.
Recommended Products
