Your cart is empty.
Your cart is empty.This motor is a 4.3", 1 stage, 120 volt, B/B, peripheral bypass motor.. the country of origin of the product is China. The brand name of the product is ametek lamb electric. 120 volt. Ball/Ball.
Tom Habib
Reviewed in the United States on June 3, 2023
Much noisier than the manufacture motor but it works.
Customer
Reviewed in the United States on February 3, 2023
Fixed my worn out Hoover Guv. Very easy to install.
Customer
Reviewed in the United States on July 22, 2022
Was replacement for garage vacuum.
Rick A
Reviewed in the United States on November 17, 2022
My GUV is back in business. The old motor didn’t like the drywall dust, took out the bearings. Don’t forget to get the motor gasket as the old one is glued in and comes out in pieces.
Mike
Reviewed in the United States on April 10, 2022
Would not fit
Clyde Logan
Reviewed in the United States on February 28, 2021
I have a Hoover Garage Utility Vacuum (GUV) , Model L2310.. After a few years, the original motor began to produce an acrid burning odor, although the suction was still fine. This Ametek motor was a direct replacement. It used the original mounting frame and screws and the original rubber gaskets. The gaskets, top and bottom, were in very good shape, so I ordered only the replacement motor. Installation was a breeze. Just strip insulation from the two wires, and connect just like the original. It took roughly 15 minutes. There is no odor from the replacement motor. It does make a strange noise at shutoff, just as it comes to a halt. If this leads to any problems I will return to edit the review with a followup report.Followup - the shutdown noise went away after a few dizen uses, and things are fine with the motor.
kerley
Reviewed in the United States on February 15, 2021
Works like it used to when it was a new garage vac
MplsBuyer
Reviewed in the United States on April 13, 2021
Hard to get parts for the Hoover GUV. But luckily the motor had the Manufacturer and the part number. Sure enough this was an exact fit. This didn't come with the mounting bracket, or the rubber "cup" thingy that goes between the motor and bracket, but mine was fine (slipped right on). I also added a Ametek #566 Gasket to replace the one that got ripped up (stuck to the motor when removing it). Worked good as new. If the rest of the GUV is in good shape, this is a relatively inexpensive way to get up and running again.
Recommended Products
$153.69
$ 60 .99 $60.99