Your cart is empty.
Your cart is empty.Auto Meter 2391 Autogage Electric Mini Oil/Volt/Water Gauge with Black Console 1.500 in.
DV
Reviewed in the United States on July 17, 2024
Look great snd look to be well made. Nice compact design. Worth the money, glad I didn’t get the vheap ones.
Marise Muise
Reviewed in Canada on June 23, 2024
Great stuff we loved them they work great
Dan Sturm
Reviewed in the United States on December 18, 2024
Easy install. Good instructions. Work great!
ctool
Reviewed in the United States on April 26, 2024
I really like the gauges and in the contents it specified all the parts that was in the box and when I received it there was no harness to hook the gauges up, I know I bought a open box and there was a notation stated that is was like new and it was new the box was damaged and that's OK but I needed all the parts.
Olli K
Reviewed in the United States on July 30, 2023
It works great. I see everything what I need plus it was easy to install.
Konstantin
Reviewed in the United States on June 8, 2023
Bought this gauge set to monitor the coolant temp after the cluster on my VW Eurovan went nuts and started showing overheating even on a cold engine. The readings seem to be accurate and the installation wasn't that difficult. Just pay attention to the wiring and follow instructions. I wired it through a relay that is controlled by a random wire that's always hot on key on that I was able to find behind the dash instead of wiring it directly to the ignition switch. Depending on your engine you may also need a tee for to instal the oil pressure sender and a hose joint with 1/8 NPT port for the coolant temp sender.
Rob
Reviewed in Canada on June 11, 2023
After two previous clusters that lasted very short times, this one is attractive on the lower dash edge, works well via sending units and wasn't too difficult to install (though we had to make an exaggerated modification on the engine to accomodate the large coolant sensor.) It hasn't been long but so far I'm impressed witrh this one.
mike switalski
Reviewed in Canada on April 22, 2023
Ls swap 944
Glenn T
Reviewed in Canada on August 16, 2021
Sweet price, fast delivery, great accuracy and fit the dash really well especially with limited space without cutting any holes to accommodate.
Brian Arsenault
Reviewed in Canada on March 13, 2021
the car only had a fuel gauge and idiot lights for charging, temp and oil pressure. these gauges look ok as an aftermarket installation.
Dan VanBerkum
Reviewed in the United States on December 5, 2019
They are listed as a 2 inch gauge, but are smaller. They all work fantastic, and wired up easily. I was able to remove them from the pod and retrofit them into the factory instrument cluster in my 73 K10. They fit well, are accurate, and function as they should. Only issue I have is they are slightly difficult to read because of size, but are legible.
calandra phoenix
Reviewed in the United States on November 20, 2018
Fit into these to my 1987 Toyota 4 wheel drive pickup. Truck only came with a temperature gauge from the factory which no longer functions. These Auto Meter gauges were very straightforward to install, work flawlessly, are readily visible where I installed them on the dash, and the size is just right for my smaller truck. Highly recommend these.
TheFixer
Reviewed in the United States on September 29, 2011
Easy to follow instructions make wiring these gauges a snap. It can be time consuming, but not all that difficult. I daisy-chained all three gauges and their lights together to simplify wiring. Start at one gauge with your positive wire, run that to the positive of the next gauge, and finally the third gauge. Once you have all 3 gauges' positive terminals wired together, you can run just 1 wire to a keyed power source. I did the same thing with the grounds, all three gauges' ground terminals are wired together, along with all 3 of the ground leads for the lights - all connect to 1 wire to a good chassis ground.After doing that, there are 2 sensor wires to run under the hood and one wire for the lights. One to the temp sensor and one to the oil pressure sensor. The wire for the lights can be added to the panel lights fuse or any wire that gets power when the park/headlights are on.The panel the gauges come in is a quality piece, however I did not have space to use it. I made a custom panel to fit in the space I had and cut the holes for the gauges. The small 1-1/2" size was perfect for my application.Gauge set comes with all the sensors needed and basic supplies to mount and connect wiring. Does not come with any wires.I have used Autometer/Autogage instruments for over 20 years now and have always found them to be quality products.
Recommended Products
