Your cart is empty.
Your cart is empty.
- Indicator lights are used in the telecommunication and electrical circuit for indicator signal, accident signal, fault signal and other indicator signals
- Adopts LED lamp with the characters of long life and low energy consumption, its concealed terminal is both safe and creditable.
Moe
Reviewed in the United States on September 5, 2024
These are very bright and visible from afar.
Dennis G.
Reviewed in the United States on March 18, 2024
The media could not be loaded.
RAY
Reviewed in the United States on December 19, 2024
GREAT SIGNAL LIGHT!
Jeffery M.
Reviewed in the United States on November 22, 2024
They are not as high quality as I was expecting but I guess they are ok for the price. I ended up using a better quality one I found at Ace Hardware only because it had a better look when illuminated. I will find another use for these later.
MTC
Reviewed in the United States on May 16, 2023
Needed a BRIGHT indicator light that was easy to see at a distance in daylight. This works to perfection in that regard. Sadly, the lamp I installed burned out in only 5 months. Perhaps that's why they're sold in packs of two? I expect an LED lamp to last AT LEAST as long as an incandecesnt lamp would, and definately they should last longer. So, it's bright all right, but durability is unacceptable.
Jude nicole
Reviewed in Canada on October 21, 2023
perfect size. like the color. easy screw in wire contacts.
Shawn Parsons
Reviewed in Canada on February 1, 2021
Worked exactly as expected, great little led indicator light
Jules Poisson
Reviewed in Canada on October 31, 2020
Description and price ok
hb
Reviewed in Canada on January 9, 2020
This 110 VAC LED pilot light is exactly as described, and is excellent value for the cost. A few comments:- it is very bright, and easy to see over a wide range of angles at considerable distance- it is designed to be mounted into a standard 7/8" diameter junction box knockout hole- recessed screw terminals are provided. These terminal screws are relatively small and not very robust - I would suggest using a segment of wire no larger than 18 gauge to connect this pilot light, and take care when tightening the screwUpdate April 2020 - first one I installed has failed after 3 months of usage. Second one has now been installed to replace it.
Top Cat
Reviewed in the United States on January 19, 2020
I bought it to indicate when the furnace in my workshop is turned on. I couldn't believe the quality for the price.
Meran
Reviewed in the United States on April 22, 2020
The size of these indicators is bigger than the picture. The hole they fit into is .75 inch, The top is 1 inch diameter, they entire unit is 2 inches long. Once installed you won't be able to miss when they are lit.
random eng dude
Reviewed in Canada on December 5, 2018
Meets my needs, wanted something to show when heating element turned on with home built controller. Listed specs accurate. Price was reasonable, I'm sure I could have got cheaper direct from Asia but would've waited too long. Happy with it.
Lisa
Reviewed in the United States on May 21, 2016
This light fit right into a knock out port on a junction box which is exactly what I needed. You will need to supply wires to install it, I used 18 gauge, but once installed it works as stated. This light is very bright; I have it set up with a solar hot water relay pump in my garage and when the pump comes on the light goes on. Since the pump is extremely quiet this light lets me know when it is on.
Recommended Products
