Your cart is empty.
Your cart is empty.Product Description
Lora
Reviewed in the United States on February 28, 2025
Works well
Tye. Morris
Reviewed in the United States on August 22, 2024
Disks didn't last as long as the more expensive ones I have had.
Robert Otwell
Reviewed in the United States on August 17, 2024
I use several hundred of these a year in my shop. Pricepoint and quality are spot on.
Beach Dweller
Reviewed in the United States on November 11, 2024
Benchmark is hands down the best value for consumables! A 50 pack costs the same as 5 from a big box store.Professional welder/fabricators dream. They cut well, last just as long as any other disc! Have yet to have one blow up and have run thousands of them to a nub. Even got a shop i previously worked at to make the switch.. DO IT!
Matthew Walker
Reviewed in the United States on October 12, 2024
Best discs. Can use a single disc for prob 50 feet of 1/8-in cuts, if not more. Just take it slow - don't try to lean into the cut too much - and you'll cut straight and keep a single disc for a LONG time.
Marvin
Reviewed in the United States on September 18, 2023
I have purchased these several times and will continue to use them. They cut fast and hold up well. I have only used on carbon steel so not sure how they would last on stainless or non-ferrous metals.
Mother of 1
Reviewed in the United States on July 9, 2020
These have to be some of the best cutting disc's I have used in my 24+ years of welding! I had to fabricate tow hook rings for my 4x4 last week and I was able to cut 11'' of 1/2'' steel plate and 8'' of 1/4'' flat steel bar and was able to with one disc. These disc cut smooth and quick! Normally while cutting 1/2'' plate the disc will over heat and start to cut very slowly but these cutting disc when threw the plate quick and easy. They cut better then the 5 dollar disc at the welding supply shop and last way longer then the Harbor Freight disc's by a long shot. It cuts threw 1/8'' cold roll plat like its nothing with very minimal wear. If you use a lot of these every year like I do I highly recommend them for there price and quality.
M. Joy
Reviewed in the United States on June 12, 2020
Thesr wheels are unrivaled. They are priced cheap and out perform all mame brand counterparts.I used one to cut steel angle stock, bolts, and other hard metals. They cut a nice thin line that leaves a surgical appearance that looks clean and neat. I removed a section from the rear angle of my utility trailer so I could re-deck the wood. The removed sevtion was easily fitted to weld back into place afterward - and after the weld was ground smooth and painted - the seams were undetectable. The 25 pack is a great bulk purchase and will last a very long time. I recommend these over all others.
Recommended Products