Your cart is empty.
Your cart is empty. Applications
The anchor is made from Zamac . This anchor is designed for use in Concrete, Block, and Brick.
Environment
The anchor is designed for use in a Moist environment.
Hole Diameter/Bit Diameter
The anchor requires a 1/2" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.
Minimum Embedment
The minimum anchor embedment into the concrete is 1-3/8". Therefore, the anchor must be installed so that a minimum of 1-3/8" of the anchor is embedded into the concrete.
Spacing between Anchors
Each anchor must be spaced a minimum distance of 5" from each other when measured center to center.
Edge Distance
It is very important not to install the anchor any closer than 2-1/2" from an unsupported edge of the concrete.
LSP
Reviewed in the United States on October 6, 2019
Just what I needed to attach the panels at the bottom.
LSP
Reviewed in the United States on October 6, 2019
Just what I needed to attach the panels at the bottom.
Recommended Products
$63.99
$ 27 .99 $27.99
$17.99
$ 7 .99 $7.99