Your cart is empty.
Your cart is empty.You will find numerous uses for this portable dust collection/air handling unit. Great for woodworking machines and laser engraving. It uses a compact but powerful 1. 5HP 110/220V motor to move air to over 850 CFM. Light-weight and portable at 46 pounds. Prewired for 110V. Comes with instructions to convert to 220V. 1 phase. 18amps at 110V. Max Static Pressure 8. 5". 9" Steel Impeller. 3450 RPM. 4" Inlet. 4" Outlet. Bag and hose are not included.
Michael C.
Reviewed in the United States on August 19, 2024
Most units of this size had poor reviews, I purchased an inexpensive unit with decent reviews and immediately returned. This unit is substantially more powerful & more expensive and by all indications thus far, worth the money. I have about 15' of 2-12" hose line running from my panel saw to this unit, several feet of hose runs vertically above the saw. This unit does a nice job of capturing saw dust from the most difficult to collect from piece of woodworking equipment I have in the shop. This unit does a very nice job of dust collecting on other equipment such as my Shop fox planner & Delta Uni-saw. Mike C.
James Davis
Reviewed in the United States on March 23, 2024
Exceeded my expectations, used to remove 2200 sqft of insulation.. Worked awesome.. built great..
John Selca
Reviewed in the United States on January 3, 2024
The media could not be loaded.
Edward
Reviewed in the United States on December 1, 2023
great vacuum for attic fiberglass insulation project.
Corgi Bum
Reviewed in the United States on April 29, 2021
I have an Epilog in my home office and my fume extractor just can't keep up when I cut lots of wood. The HEPA and pleated filters are ridiculously expensive to replace so I needed an alternative means of fume removal.I purchased this blower about 6 months ago, but I just finally got to setting it up. I have it connected at the end of a 70 ft run of 4 inch rigid ducting. I have it plugged in to a variac so that I can fine tune the amount of suction that I need--to minimize the amount of noise. Even with the long run of pipe and lower voltage, this blower is still powerful and has no problems pulling wood cutting fumes from my Epilog.I considered getting one of the popular inline blowers on Amazon, but after comparing specs, this thing has roughly 9.5x x the amount of static pressure (2117 pa vs 223 pa).
Mr. Jones... and me. and myself. and I.
Reviewed in the United States on May 26, 2020
The media could not be loaded.
charles ettinger
Reviewed in the United States on September 4, 2018
i have a laser engraver and this made the difference in fume extraction. so far, so good.
kenneth snell
Reviewed in the United States on May 9, 2017
Use it with a 60 watt laser with a 2' x 3' bed. So far there are no fumes escaping from the machine. Very happy with this product.
Recommended Products
$12.69
$ 6 .99 $6.99