Your cart is empty.
Your cart is empty.Elkay Products has been an importer and distributor of hand tools, drill accessories, hobby tools and polishing accessories since 1952. Elkay's mission is to provide customers with a less expensive alternative to the larger more expensive tool distributors without compromising quality.
Glenn
Reviewed in the United States on April 4, 2024
Did what was needed.
bEnJAmIn
Reviewed in Canada on May 11, 2022
Max rpm's on the blade reads 2500 or something but it works great at 17000 still on my dremel. I'd buy again.
Jeff j
Reviewed in the United States on June 13, 2021
Poor wood cutting
Customer
Reviewed in the United States on November 10, 2021
Item did the job for what I needed it for. Which was a very short run of cuts through some worn out particleboard. It doesn’t give a very accurate cuts, it’s very slow going, and it likely isn’t going to last for many uses at all. But, for the short and very simple task I needed it for it managed to get the job done. It went in the trash immediately there after. From that perspective and combined with the fact that it isn’t expensive, I suppose it has some value.
Customer
Reviewed in the United States on June 29, 2019
Exactly what I wanted...this is a mighty little cutter
fred bozek
Reviewed in Canada on May 9, 2019
it bends easily so cuts on an angle,to thin
Phyllis Bilkey-Behrns
Reviewed in Canada on January 5, 2019
Be careful on side pressure otherwise it works well
Scott Thomas
Reviewed in the United States on May 31, 2018
The cutting wheel kept coming loose off the shaft, so it was a bit annoying to use. It was VERY sharp and cut well when the saw wheel stayed fixed and not spinning freely.
Sacto1951
Reviewed in the United States on May 21, 2018
I bought this for a one time project. It works well. My only concern is safety. Unlike all saws I use, there is no safety guard. Drill bits don't have a safety guard, but are much smaller.
Detlev Grabs
Reviewed in Canada on August 13, 2017
Works just fine with my Dremel
frog
Reviewed in the United States on August 12, 2014
Works great! Could not find one this inexpensive anywhere locally! Cut thru some 1/4" pine just fine.
Mitch Bowers
Reviewed in the United States on July 25, 2014
It cut okay, but it would be better if it was thicker and more sturdy.
Recommended Products
