Your cart is empty.
Your cart is empty. Brand New Coated Carbide Inserts
Box of 10 inserts
It is commonly used on Non-Ferrous Metals (Aluminum)
Used for General Cutting
Insert Style:APKT
Insert Size: 1604
Material: Carbide
Material Grade: Aluminum used
Josh Butts
Reviewed in the United States on August 8, 2024
Chews through 6061 like butter, mirror finish. Can't beat these for the price.
Cindy A Disko
Reviewed in the United States on June 6, 2024
fit our tooling on hand and handled the d2 like a champ will order another pack or two.
Étienne G B
Reviewed in Canada on February 29, 2024
With these I get a mirror finish on both steel and aluminium.
Grant
Reviewed in the United States on July 31, 2023
Honestly wasn’t expecting much out of these but they’ve chewed through CR and HR plate without any issues. Even ran some Ti with them and they did the job. Obviously there’s better stuff out there but for a cheap insert they hold up awesome
Darrell Dill
Reviewed in the United States on June 29, 2023
These inserts swill eat their way through aluminum like nothing else. I put them in a 2” diameter face mill. With a spindle rpm of 4000, a depth of cut of .300”, width of cut set at 1.75” and chip load of .015 per tooth. The chips fly off like a rooster tail. I have only used this on an enclosed machine.
Ray P.
Reviewed in the United States on January 9, 2023
I use these inserts in both a 2" and a 3" face mill, frequently on 304 stainless. Surface finish is great and they hold up pretty well. They have 2 cutting edges per insert. They are inexpensive so I I feel I am saving money and don't mind changing them out when they get a little dull. BTW, awesome on aluminum, and heavy cuts are no problem in a Bridgeport.
Sr. Castillo
Reviewed in Mexico on August 20, 2022
Maquinado en acero duro.
Fernando Quijano Pereira
Reviewed in Mexico on May 25, 2022
Deja un muy buen acabado en espejo
robert e lutz jr
Reviewed in the United States on November 3, 2022
picture shows 20 inserts... the order says price is for 10 inserts.... a bit of a little trick....
mrproduxn
Reviewed in the United States on February 4, 2021
I had a hard time finding reasonably priced inserts for my hobby machining. I thought I would try these even though they are square cornered. I would be much happier if they had a 0.015" to 0.030" radius. Even square cornered I managed to face and contour cut nearly 200 pieces of material with one corner. They lost 0.002" on the length over the 200 parts. I am very satisfied with the results. Now if I can find these same inserts with a slight radius they will be my primary inserts for aluminum. Would def buy again.
David
Reviewed in Canada on December 14, 2021
cutting aluminum they work very well nice sharp square corners
DanielABonn
Reviewed in the United States on November 20, 2021
Originally these had no lifespan, but then I lowered the tip speed, they perform very well now.
Recommended Products
$35.00
$ 17 .99 $17.99
$25.99
$ 12 .99 $12.99