Your cart is empty.
Your cart is empty.HHIP expanding chuck arbor in machine to be used. Tighten expanding screw so that arbor expands 005 inch machine arbor to Length and size required. Loosen expanding screw. Position part on arbor and tighten expanding screw. Product specifications: size: 1"; Length: 4".
Lance Barney
Reviewed in the United States on November 20, 2024
These are to short to use to hold anything of length on a wood lathe.
HillbillyMo
Reviewed in the United States on April 8, 2024
Seems good quality, haven't had a chance to use yet. Shipping time was descent.
squachin69
Reviewed in the United States on April 22, 2024
Got this for turning duck call barrels. Works as intended, however there are sharp edges. I was able to file down the sharp edges then run some sandpaper to finish smoothing. Not a huge problem with wood barrels, but when turning transparent acrylic you can see the scratches it leaves.
Ron Weber
Reviewed in the United States on May 19, 2023
You cant even sufficiently tighten the expanding screw with an allen wrench without it rounding the corners off
Fred Wienbarg
Reviewed in the United States on February 2, 2021
Not long enough to be worthwhile. No wrench supplied to expand mandrel. Don’t waste your money!
Shirley Hamilton
Reviewed in the United States on December 21, 2021
This is no good should have known better from the review the bolt fits nether standard or metric hex wrenches and even if it did there is next to no hex depth in the bolt so would strip if you tried to tighten .
Jordan Pagano
Reviewed in the United States on March 14, 2019
The hex key in the screw was a very poor fit and pretty much unusable. Thread was full of swarth and not well cut.
Ken Buswell
Reviewed in the United States on March 12, 2019
The expanding arbor will not expand. Do not buy.I sent it back for a replacement. Same thing with the replacement.
Recommended Products
$17.29
$ 7 .99 $7.99
$87.16
$ 34 .99 $34.99