Your cart is empty.
Your cart is empty.9410 is an electrically conductive, silver-filled, one-part epoxy adhesive. It is smooth, thixotropic, non-sagging, and bonds well to a wide variety of substances. It has an unlimited working life at room temperature. Attention! this product must be heat cured. This product can create electrically conductive bonds where soldering is not an option, such as when bonding to heat-sensitive components, glass, soft metals, or conductive polymers. It also works well in semi-conductor packaging, micro-electronic attachment and lid-sealing, and as a die attach for small chips, LEDs and diodes. It does not require mixing and can be readily used in manual, Pneumatic and robotic dispensing processes. 9410 has been formulated to have a high TG. For a lower TG, use 9400.
Dawn
Reviewed in the United States on January 25, 2022
For the money spent on a small market product that you can not find readily you would expect it to show up in working order. It was USELESS as it had gone bad probably years ago and was sitting on a shelf till the next poor sap ordered it. Please read all the reviews and do not buy this trash. Now I have to ship it back to get my money refunded. What a huge waste of time.
Ray
Reviewed in the United States on February 14, 2021
Make sure you wear protective gloves.
Chris kim
Reviewed in the United States on December 25, 2021
Waited long time to arrive and and finds out ita all dried and no good.what a waste of time
Fred E. Elum
Reviewed in the United States on January 20, 2021
I bought this for a project that I was unsure if I could heat. I did not want to use my low temp solder. When it arrived there is paper in the packaging, but no instructions. I found the TDS on the manufacturer website. It must be heated to activate the epoxy. Higher temperature give shorter cure time. If this information were in the description I would not have purchased. Curing is between 90C-120C for 60-7 minutes. My low temp solder activates at about 125C, so it is little benefit. It does not have any adhesion until cured. It did not run , but it did not hold the pieces together until I could heat it. It has a very distinct formaldehyde odor when curing. Don't breathe the vapors.UPDATE Jun 2021: It seems to work as intended. Additionally, the seller seems to have updated the listing and information to include that it must be heat cured. That information was not present when I bought it. At over ten bucks a gram instructions should be provided....
thomas
Reviewed in France on March 6, 2020
texture pas fluide et pas moyen de la faire catalysé malgré 2h a 80°
Rick Barnier
Reviewed in Canada on November 7, 2020
Went to use the product for the first time and it was all dried up on the inside. Lost a customer due to this.
Scott
Reviewed in the United States on October 7, 2020
The title for this product should be much more explicit - this adhesive requires a minimum of 70 degrees C/158 degrees F to cure.
Customer
Reviewed in the United States on January 6, 2020
Works awesome, used to bond aluminum wires to copper pad. Worked perfectly.
Benjamin
Reviewed in the United States on January 2, 2020
This product is very easy to dispense and use. No mixing is required and it is very conductive too.
Adrian T.
Reviewed in the United States on November 1, 2019
The shelf life of this product is not unlimited and it had clearly expired or been stored in an environment that was too warm. It was fully cured and unusable. It did not ship with any certs or expiration date documentation so who knows how old it was. I bought the two-part system to replace it because the shelf life is much longer than the one-part
Recommended Products
