Your cart is empty.
Your cart is empty.High quality indicator lights made of nylon with polycarbonate lens material and neon lamps. 125 Volt rated. Connection with 6 inch wire leads. UL recognized, CSA certified. 1.22-Inches height. 0.5-Inches panel cutout. 0.030 - 0.093-Inches panel thickness. 0.09 function Yale lens style. Red lens color. Diamond lens Type. Chrome bezel color. Type of fit: press. Mounting hole diameter: 0.5 inches.
Customer
Reviewed in Canada on January 21, 2025
work fine
Rheinhardt Farr
Reviewed in the United States on September 15, 2024
I purchased this for a dummy oil light in my sandrail as it requires incandescent bulbs for their resistance. This light did not work right out of the package as well as another one I purchased of a different color. They're cheap so I'm not too burnt on the experience but I will never order these again
Bruce C
Reviewed in the United States on February 5, 2024
Easy to install and hook up....good brightness
Customer
Reviewed in Canada on February 10, 2024
Convient très bien sur mon panneau comme lampe indicatrice.
product reviewer
Reviewed in the United States on December 24, 2024
Looks great. Used in a guitar amp missing power led. Great quality. Great value. Looks like it’s meant to be there on the amp. Perfect size.
Steve M
Reviewed in Canada on December 17, 2024
Just as advertised.
Tad
Reviewed in the United States on December 15, 2024
Worked great. Was pleasantly surprised to see it was made in the USA. High quality light.
Gene Slay
Reviewed in the United States on October 7, 2024
Easy to install and works great.
Mike
Reviewed in the United States on November 21, 2023
Since this is an electrical stove part, I wanted something that is safe, and this light is UL Listed. High quality part, nice replacement for burned out indicator light.
Mike Kuun
Reviewed in Mexico on June 11, 2022
Funciona como se describe, fácil de instalar, directo a 110v
ANTHONY L WELCH
Reviewed in the United States on September 29, 2020
Not bright enough
mike
Reviewed in Canada on July 22, 2020
i have a 30+ year old commerical table top stove and i couldnt get the old bulbs anymore but these were the right fit popped right in.. so i chopped off the older connectors and soldered the old ends to the new bulbs and bobs your uncle... works great.... as i needed 2.. for 4 burners...so was a great buy
EF
Reviewed in the United States on November 10, 2018
Most important. This is an actual neon lamp not a LED replacement.It a very well made lamp. Proper isolation of the resistor from the lamp itself prevents shorts. Wires crimped to the enclosure body means there are no loose wires shifting around which could cause fatigue and an intermittent connection.The only downside is this is not a replaceable neon lamp. Completely non serviceable. I decapsulated the lamp so I could change the resistor. The lamp did not arrive in pieces (as shown in photos). There is a crimped on aluminum band that holds the diffuser to the enclosure. It can be replaced if you have the specialty tool.The lamp has a 30k resistor. Based on the size of the lamp it appears to be of the 90v variety and thus has a power consumption of 90mW (1mA) @ 120v. It is quite bright even operating at 1mA; daylight visibly bright. I changed the resistor to a 220k for operation at 240v. The lamp is still visible under room lighting at 120v and bright under 240v; even though the current has been reduced to (0.68mA). If you decide to mod your lamp you can likely stretch out the lifetime by a large multiple (4-5x rated life) with little noticeable reduction in brightness.
Recommended Products
