Your cart is empty.
Your cart is empty.donesp
Reviewed in the United States on May 12, 2024
Works great. The price was reasonable and the build quality was exceptional. Would buy again when needed.
Kentucky Guy
Reviewed in the United States on March 24, 2024
These will work perfectly to connect a steel shaft to a 3/8" motor armature.
Rodney N. Porter
Reviewed in the United States on October 17, 2024
Fits
Kurt
Reviewed in the United States on September 23, 2023
Clamps down very good. Nice fit and function.Arrived faster than expected. Would buy from them again.
redtreetoad
Reviewed in the United States on April 11, 2023
For a while I thought that the set screws used a odd size hex key that I didn’t have. After going through all my metric and SAE hex keys (I have about 100 hex keys of various sizes), the closest fit was a 1/8” hex key. I tried 5 different 1/8” hex keys to tighten the set screws, and all of them were a tad too small for the set screw hex holes. You can tighten the set screws to a decent amount, but if you want to really crank them down, the hex key will undoubtedly slip and strip the set screw or the hex key. I measured the bore of the coupling with my Starrett calipers, and it read 0.3745” (within 5 mills of 3/8”), so other than the set screw issue, it fits just fine on my stepper motor’s 3/8” shaft.
Melissa Miller
Reviewed in the United States on May 3, 2021
The set screws do not bite into the rod well and pulls off. I replaced with bolts and it works.
Dennis Mountains
Reviewed in the United States on October 31, 2020
I have a 3/8" round D shaft on the motor connected to a 3/8" threaded rod. This coupler holds tight on both the motor shaft and the threaded rod.
Dean Winters
Reviewed in the United States on January 29, 2018
Worked perfectly. Needed to swap out the engine on my old ariens snowblower, and the new engine interfered with the shaft used to move the throw chute. Used it to add an extension into the shaft before the universal joint and works perfectly.
Recommended Products
