Purchased and installed the RV Backup Camera system by Yakry. Installation was on a 2021 Jayco White Hawk 36 ft trailer. The trailer was pre-wired for the Furrion system, so the installation was straight forward. As a note, to power the camera, your vehicle will need to have the parking lights on so that you will be able to view the rear. when the trailer is connected to the tow vehicle. The installed camera is a game changer since I will have an easier time maneuvering into RV spaces and on the road, give a clear view at the rear of the trailer. Pairing the camera was easy and I like the dual antenna on the monitor to maintain a clear connection. I also like that there was all the necessary parts included in the kit to perform the installation, and I can order additional cameras to expand out to 4 camera/channels on the system. Overall, I am pleased with the purchase.

This is a great RV Observation/Rear View/Backup Camera. I purchased this to replace a Furrion camera on my large fifth wheel. The install took about 10 minutes with the supplied plug-in adapter. The Yakery metal camera bracket attached to the existing Furrion housing. The camera/monitor resolution is crystal clear. The range is excellent. I powered up the camera on the RV and was able to drive the monitor away from the camera about 30 yards with excellent reception. I installed a 128GB SD card and the system started recording when powered up. I adjusted the recording loops to 3 minutes. I have no cigarette lighter on my new truck but I was able to use a USB to cigarette lighter adapter to power the monitor. I will probably tap into a 12v power source with one of the supplied power cords. I stuck a metal disk onto the back of the monitor and was able to use my phone mount in the truck to hold the monitor. I had one question and was very happy with the knowledge and response from customer service. I also am impressed with the warranty timeframe. I'm so happy with my purchase. If anything changes, I will update this review

The camera and monitor were packaged securely. Included is a wide range of cables and fixings to cope with most configurations.The quality of the items is impressive. The screen resolution is HD and very clear. The camera feed is up to the demands of the screen.The fitting instructions are clear. The monitor and camera can be tested using the power plug with a splitter cable, which is a nice touch. The adjustments to the camera and monitor are comprehensive, easy to understand and to work through.The camera can act as a dash cam and record to an SD card, not supplied, located in the monitor. You have to format the card in the monitor before use. However it is a little unclear when this has been completed as there is no dialogue telling you.I fitted the camera under the rear valance of my 8 mt caravan, routing a separately purchased power cable to the leisure battery at the front of the caravan. Due to the size of the monitor, and the dash configuration of my car, a large SUV, I put the monitor on the passenger side using the windscreen mount. Careful siting is needed to ensure that the monitor obscures the windscreen to a minimum. The windscreen mount is a bit fiddly but holds the monitor solidly, with plenty of adjustment possible.I had a query about a free gift mentioned in the instruction manual. My query was responded to very quickly as were subsequent emails. I got the impression that, if there were questions about the system, the company would be equally responsive.On the first journey out using the system, I towed for over 4 hours over motorways and A & B roads. The screen clarity was excellent with the signal strength high and rock solid.All in all I have no hesitation in recommending this system.

The camera has an excellent video quality and feed, it's easy to set up and the hardware needed to install on the furrion mount that was pre-install on my rv is included. The price for this system is very reasonable given the quality, you not going to get any better even if you spend money on a more expensive system. Over the years I have made a lot of orders on Amazon, and at times I had to deal with the seller with good and bad service. When I do a review I always give a honest opinion, Never have I dealt with a company with a customer service as excellent Yakry, I had a minor issue with the monitor they replied to my e-mail and told me how to fix the issue within 24 hours, had I known the service was this good and the system came with a 3 year warranty I would not have purchased the extended warranty from Asurion that was a waste of money. If you are in the market for a rear view camera I highly recommend this system.Le système Yakry est excellent, la qualité du vidéo est très bonne, tout ce dont vous avez besoin est inclus y compris la quincaillerie pour installer la camera sur la monture furrion. Le service après vente est exceptionnel jamais je n'ai eu affaire a une compagnie avec un aussi bon soutien technique. Et une garantie de 3 ans c'est imbattable.

I purchased and installed the Yakry Y28 system. It included two cameras, one 7-inch monitor, and various mounting and installation accessories. I mounted one camera on the back of my 25-foot camper and the other camera on my pick up truck rear bumper. Both cameras face backward. The camper camera easily attached to the camper camera mount using the adapter plate that came with the kit.One thing I like about this system is that the video signals sent from cameras to the monitor are wireless. This made installation much simpler since I didn’t have to install video wiring. You do need to install power wiring to each camera. The camper camera wiring was simple since a wire to connect to is included in the camper camera mount. For the pick up truck wiring I just tapped into the taillight wiring. The Yakry kit even included wire connectors.The Yakry kit includes multiple mounting options for the monitor: suction cup to windshield, adhesive mount to top of dash, or screw mount to dash. The kit includes everything you need for each mounting option. I went with adhesive pad mount. It is very sticky and sturdy. The monitor is not going anywhere.My monitor is 40 feet from the camper camera. It is a clear steady picture. I have never lost the signal. The monitor has views for four different cameras in case you want to add two cameras in future.The included instructions on how to navigate through different monitor settings could use some improvement. But there are several You Tube videos that you can watch to help.Overall I am very happy with the system. Price was VERY reasonable. Installation was relatively simple for me but I would say I am mechanically inclined. If you are not you might want to get some help. Monitor picture is excellent.

Have installed this system on and in my horsebox - rear view and interior view. Picture quality is outstanding- bright, colours real and swap between infrared and normal is instant. Easy to install, good functionality and means I can see what’s coming up behind me. And the camera lens clears rain etc quickly. My only comment is that the twin camera view is in portrait so side by side which limits it a bit. Am checking to see if Landscape is possible - if not am suggesting to the company that this may be an option to have . Otherwise this is the best system I’ve seen and highly recommend it…oh and real value for money !!!!

Very nice can i add another camera how much it cost and how can i order it

good

I have installed a number of back up cameras on various vehicles. Until now, none really had any decent resolution. This time, I decided to spend a few more dollars for a unit with excellent reviews. One of the best decisions I've made in a long time. Installation was a snap, and as soon as I powered up the camera and the display screen, they seemed to instantly pair with each other with no further action on my part.The view is very wide angle, which is desirable for a rear view camera. Best, though, the quality of the display is amazingly crisp and color true.I asked the seller to provide the second camera as stated in the listing (i'll have one unit on my truck's tailgate, mostly for lining up trailer hitch, and the other on the rear of my RV trailer). The second camera came with all attachments within a matter of days, free, including shipping.Communication with the vendor was quick and professional. The units themselves (both camera and screen display) have a very hefty, confident feel to them, not at all like most of the cheesy plastic units out there.------------------------------------------------------------------------ UPDATE MARCH 2021As stated in the listing, the vendor will provide a FREE second camera upon request after you receive your initial order. I planned on using one camera (with a strong magnet mounted on the back) as temporary use when connecting my truck and RV trailer together. The second one will be mounted on the rear of my RV trailer.However, I had a hell of a time getting the second camera to pair. The vendors were responsive to my questions, but still it took 5-6 emails over a period of 7-10 days to finally get it resolved. There may be an easier way, but these are the step-by-step instructions I employed to finally get both cameras paired to the display unit:PAIRING INSTRUCTIONSThe pairing has to be done for a designated Channel/Camera .There are 4 possible channels.. if you press the CH button on the display unit, it will show the channel (camera?) number selected in upper LH corner.The initial camera comes paired, of course, with the channel 1. If you try to pair the second camera while channel 1 is being displayed, that camera over-writes the pairing for that position, so that the original camera is now no longer recognizable.Here's the step-by-step process that worked for me:1) Make sure both cameras and display screen are powered ON (If cameras are plugged into vehicle or RV wiring, then this means turning on your "running lights" to provide power2) Press Menu, then +/- to highlight the CAMERAS menu.. Turn OFF cameras 3 and 4 so your display will only cycle between cameras 1 and 2 (This takes some fiddling, but eventually you'll figure it out)3) Once out of the Menu, the originally supplied camera's output should be displayed on the screen, with CH 1 displayed in upper LH corner4) Press CH once so that CH 2 is displayed in LH corner. The screen should show "No Signal"5) Press Menu, then OK while the PAIRING menu is highlighted6) The "Pairing" countdown will begin.. as soon as it does, disconnect the power to the target camera for 3-4 seconds, then plug it back in before countdown finishes7) If all goes well, you will now see the output of camera 2 displayed on the screen8) Press the CH button to toggle between the two camera displays9) Once paired, both cameras should come alive when powered up with no further future pairing required.10) Note that in the menu you can choose different screen presentations.. for example you can choose to have both cameras displayed on 1/2 half screen, side by side, or just one camera at a time, chosen by pressing the CH button