Your cart is empty.
Your cart is empty.Product Description
How to use it?
The method of jointing the ends of the belt:
Step 1: To be heated with an alcohol lamp until it is hot enough to melt the end of the belting.
Step 2: Join the ends together until they cool.
Step 3: Trim off the extra material around the joint until the joint is the same diameter as the belt.
Application:
It is widely used in the transportation of packaging machines, printing machines, textile machines, transmission wheels, ceramic tiles, cement tiles, floor tiles, wooden products, food cans, newspaper prints, etc.
Jeffrey Summers
Reviewed in the United States on October 31, 2024
this worked great. cut it to length and glued it together.
Pete Zimmer
Reviewed in the United States on April 1, 2024
Works fine lasts a long time.
Louis Cimon
Reviewed in Canada on December 13, 2023
Almost no elasticity so it is unusable. I returned it for refund.
Jorge
Reviewed in the United States on April 13, 2023
Meets my requirements to make a belt
James
Reviewed in the United States on July 26, 2022
Worked great on my faceting machine. Runs very smoothly.
Jeffrey Barnhill
Reviewed in the United States on November 22, 2022
Easy to cut and melting the ends together not too complicated. Not as pliable or stretchable as expected, so was unable to pull the belt tight on my 12 vdc solar powered motor. But the material had enough grip that I was still able to run it a little slack and make it work. Material does feel like it would take some tension and not snap.
Joe M., White Lake MI
Reviewed in the United States on March 24, 2021
Perfect replacement for belts on an old key cutting machine. I couldn't find replacement belts, so I made them. Simple to make replacement belts with a torch, box cutter blade and a vise. I wrapped the material around the 2 pulleys and marked a line. I then cut 1/4"-1/2" shorter than what I marked to add tension when finished. Clamped a box cutter blade in the vise and heated the blade with a torch. I touched each end of the o-ring to the sides of the blade, melted them and slid them off the blade and held them together for about a minute. The ends fused together well. Cut off the extra melted bulge where I fused them together (grinder helps) and installed it immediately. Worked like a charm! Easier than I imagined.
Butch
Reviewed in the United States on October 7, 2020
I cut the ends at an angle before connecting them together. I used a heat gun which worked perfect, then I sanded off the melted axcess at the splice. Very easy to work with material. Works great!
Isaac Clark
Reviewed in the United States on August 9, 2019
First time using this kind of belt and had no trouble joining it. I watched a couple YouTube videos on joining the ends together. The method I used was heating a utility blade up with a torch and then holding the ends of the belt against it and sliding them off and into each other. Worked great, made up two belts first try.It's a month later and they are still running great.
Recommended Products
$13.67
$ 5 .99 $5.99