All Yak Power switchers are designed to make it quick and easy for you to add and control 12v electronics on your kayak. With up to 8 switched outlets, you can connect your fish finder, bait well pump, LED lighting, phone charger, navigation lights, or any other 12v accessory you need out on the water. Featuring Yak Power plug-and-play SAE termination, all accessories can be easily connected and controlled independently using individual buttons on the control panel. Each button turns RED when it is activated making it easy to see which buttons are in use. And, the Master Power switch allows you to completely power up-down the entire system with the press of a button to minimize your power consumption while out on the water.

Warning: If connecting a trolling motor, large LED light bar, agricultural sprayer or other high current electronic 12V device you MUST use a secondary YP-LDR50 Heavy Duty relay and the correct size gauge of wire on the load side of the relay between the relay and the device you are connecting. You must also use the same size gauge of wire on the battery connection to the relay to insure proper function and protection of your device. Please consult the specifications for the device you are connecting for proper wire sizing BEFORE installation.

Make sure the plug-and-play connectors are completely pushed together when connecting the system together. Yak-Power uses our own custom tooled, high tolerance, very snug fitting connectors with larger gauge, real copper wire to ensure a quality, weatherproof and reliable connection. Using other aftermarket connectors or splicing other connectors into the YP system may cause damage to the system or the accessories connected to the system

Always make sure the polarity of the main power wire to the relay pack is correctly plugged into its mating battery power wire. The positive male (red wire) side of the relay pack connector should plug into the female (red wire) side of the battery connector and the female (black wire) side of the relay pack connector should plug into the male (black wire) side of the battery connector. This will insure that the relay pack is properly wired to power so that it can communicate with the keypad. If power is not properly connected to the relay pack or if the polarity of the battery connector is wrong, the relay pack will not be powered up and will not be able to communicate with the keypad. This will result in the keypad not fully turning on and the keypad numbers not illuminating. If you are having issues with your wireless switcher turning on, please check the polarity of the main power connector to the relay pack to insure that the battery connector into which you are plugging has the female side on the positive (red) wire and the male side pin connector on the negative (black) wire. Also, please make certain that BOTH clear battery insulator tabs have been removed from the keypad battery compartment on applicable models (YP-RP5WR, YP-RP5W-OR)