Shopping Cart

Your cart is empty.

Your cart is empty.

3/8' Flare x 1/2' NPT Male Brass Tube Fitting for Propane, LP and Natural Gas, Fuel, Half-Union (1-Pack)

4.4 (8) Write Review
Free shipping on orders over $29.99

$6.99

$ 2 .99 $2.99

In Stock

About this item

  • 45-degree 3/8" male flare on one end and 1/2" male NPT on the other.
  • Used for propane, LP and natural gas, fuel, plumbing, refrigeration and more.
  • Compatible with copper, brass, aluminum, and steel hydraulic tubing that can be flared.
  • Constructed from brass with high-temperature ductility and low magnetic permeability.
  • Contain low lead and prohibited to install for potable water use in the USA by federal law.


Product Description

1
1
Size 3/8" Male Flare x 1/2" Male NPT
Connector Type Union
Material Brass
Features Flare Fitting, Threaded Screw
Durability Rust Resistant, Leak Resistant
Applicable Media Propane, LP Gas, Natural Gas, Fuel
Applicable Pipe Brass, Copper, Aluminium, Steel Tubes
Application Hydraulic, Plumbing, Refrigeration, Vacuum, Pneumatic Systems
Temperature Range -65°F to +250°F (-53°C to +121°C)
Quantity 1 Pack
Exterior Finish Brass
Warm Tips Avoid over-tightening to prevent damage; Soap test to confirm the installation and prevent leaks.
3

SAE 45° fittings are designed for use on pipes of copper, brass, aluminum, or steel and are typically used in fuel equipment, plumbing, gases, refrigeration, and vacuum lines.


Mena
Reviewed in the United States on January 29, 2025
Threads are in good condition. This piece came with a plastic cap over the flare-fitting threads to protect them in shipping. The only other protection is a small plastic bag. Good quality for the price. If I were the seller, I would say in the description that the threads come protected for shipping. Many gas fittings on Amazon are not shipped this way. Scratched or banged-up threads can cause leaky connections. So it's important that they are protected like this in shipping.
Vic
Reviewed in the United States on March 17, 2024
Exactly as described, installed on propane stove valve. Arrived on time
r robison
Reviewed in the United States on December 3, 2024
Just what I needed
Dane W.
Reviewed in the United States on December 26, 2024
Worked perfectly
roumenid
Reviewed in the United States on December 21, 2024
GOOD QUALITY
Bernd S. Loos
Reviewed in the United States on December 17, 2024
Fit as it should!
Jack
Reviewed in the United States on December 10, 2024
It seems okay. I got the wrong one.
Jeffrey Nance
Reviewed in the United States on October 3, 2023
If you are connecting a gas stove, the 1/2 inch end must be an NPT not a flared 1/2 inch which slightly smaller or you will start a fire from the propane leak of a flared connector. The gas line 3/8 end is what has to be flared.