Your cart is empty.
Your cart is empty.4.0 out of 5 stars
- #32,256 in Musical Instruments (See Top 100 in Musical Instruments)
- #10 in Bass Guitar Electronics
Prewired 2 Band Active & Passive EQ Equalizer Electric Bass Preamp Circuit
Z3406
Reviewed in the United States on March 5, 2025
Output Jack nuts will not thread on post. Wires broken at soldered connections. After fixing all this I doesn't work at all;.. Junk
Jsims4
Reviewed in the United States on September 23, 2024
Seems well made . But beware, unless you already know how to wire it... Good luck finding instructions.
Solai Bassist
Reviewed in the United States on September 23, 2024
Doesn't come with a wiring diagram is my only complaint so keep that in mind if you are wiring it yourself
Joan D'silva
Reviewed in the United States on July 4, 2024
Llegó rápido y todos sus componentes funcionan perfectamente, el preamp es marca Mings y respondió perfecto, ya lo instale y funciona bien, seguiré comprando el mismo artículo.
That guy
Reviewed in the United States on June 23, 2024
I put these on a cheap Glarry 5 string with dual HB's and was blown away by how much better it sounded. The original pickups sounded thin and dull to me. The original pickups (still in the guitar) aren't nearly as hot as my other basses. After putting this in I instantly knew I did something right. So much more tone control. Sounds much fatter with great thump.
Carlos B
Reviewed in Mexico on February 6, 2024
Por el precio es muy buen producto, falta poner algunos cables blindados, todos los controles hacen bien su trabajo, solo el agudo mete algo de ruido, si lo recomiendo
Roman D.
Reviewed in the United States on November 29, 2024
Installed in a glarry 4 string. Now it sounds just as good as my dean edge 5 string. No problens with the wiring although directions would be nice for a novice. The blend pot board is labeled p1, ground, and p2. Awesome cheap upgrade for a cheap bass. If I didn't already have active pickups in my dean I'd install this in it as well.
JoeKickass1234
Reviewed in the United States on October 21, 2024
Tried to hook this into my bass. It connected and the bass had a signal but none of the EQ knobs hooked up properly.
JustAThought
Reviewed in the United States on November 24, 2023
It works. A fairly easy install that requires basic "soldering" skills. I put this in a Spector Legend 5 string, and it sounds great. Much prefer the tone and EQ range (treble/bass) of this budget preamp over the original. I have the "2-band" version so can't speak to the 3-band version, or longevity of either.
Recommended Products
