Your cart is empty.
Your cart is empty.This is a Dead Center Hole Locator for Locating Engine Mounting Holes. Great Planes Dead Center Hole Locater is a tool that should be in every modeler's toolbox. The tool is extremely easy to use. Simply press its self- centering alignment cone into the mounting hole with the engine positioned on the motor mount and give the handle a few turns, the sharp drill tip leaves perfectly centered marks every time].
Customer
Reviewed in the United States on March 23, 2024
Works as expected
Keith
Reviewed in the United States on August 27, 2021
This tool made a job I hate to do to one I look forward to. Thanks for a great product.
Allan1953
Reviewed in the United States on June 10, 2021
Recievd in Excellent Condition
hazan yosef
Reviewed in the United States on May 17, 2018
very good product. helping mountin the engin in perfect location
Kelli V.
Reviewed in the United States on April 18, 2018
Does exactly what it's supposed to do. Easy to use. Finally my blind buts line up perfectly with engine mount holes. Have already found several other uses for it too.Would be nice if the drill bit wasn't able to slide out. Not a big deal. Doesn't happen during use or anything, just once when I dropped it I was on my hand and knees looking for the spring.
700Saber
Reviewed in the United States on October 22, 2017
At first I didn't like this tool. Instructions say to use two hands to place it in the hole, then push down on the the spring-loaded knurled top shaft to shove the drill bit out of the bottom, then twist from the top, theoretically marking the spot (or setting a pilot hole) where you want to ultimately drill the holes. After realizing there was no way I could drill even a slight pilot hole in the engine mount by hand, I put the tool in my cordless drill. The knurled section clamped into the cordless drill-chuck nicely.The tool is super lightweight and flimsy, but I was careful not to push too hard, and I was able to drill 4 perfectly aligned pilot holes.
CM
Reviewed in the United States on January 4, 2017
Arrived as described. Would purchase from seller again.
TXJaxon
Reviewed in the United States on February 15, 2015
Excellent little tool for centering holes in small jewelry box hinges and things of the like.
Recommended Products
$46.55
$ 19 .99 $19.99
$1,554.76
$ 99 .00 $99.00