Your cart is empty.
Your cart is empty.MT1 to MT2 Morse Taper Adapter. Made from high quality alloy steel, hardened and tempered, precision ground inside and outside to high concentricity.
Juan v Gonzalez
Reviewed in the United States on September 25, 2024
Right thing.
old photo guy
Reviewed in Canada on July 28, 2023
really fills the need for only using one sleeve to go from #1 Morse taper to #3
William G. Peters
Reviewed in the United States on January 4, 2023
It fits perfect. Used to machine a number 0 morse taper to fit a jacobs chuck.
Sandman
Reviewed in Canada on January 23, 2023
The fit is great !
Polarisbonfire
Reviewed in Australia on July 24, 2020
Patently incorrect
Donn Fishburn
Reviewed in the United States on November 28, 2020
Works fine
Erich E.
Reviewed in Canada on September 26, 2017
Excellent product, does what it is intended for and more.
oldseagull
Reviewed in the United States on March 22, 2016
This was the best adapter Amazon offered . . . I wanted a "short taper" to slip into my NOVA Comet tailstock . . . Here's what I did: I slipped it onto a MT1 taper Mini-Drive Center, locked all between centers, and carefully cut it with a DREMEL EZ-Lock cutting wheel, to approx. 2.5". Carefully cleaned it up and voila! I have a "shorty" MT! to MT2 conversion adapter to use with old live center set and mini-drives to fit my tailstock.
Tony G. Shipman
Reviewed in the United States on October 11, 2016
fast and good item
tinomolloy
Reviewed in the United States on December 28, 2015
Worked great when I accidentally ordered an Arbor with a MT1 taper.
The Erstwhile Photographer
Reviewed in the United States on March 22, 2013
I was surprised that this came all the way from mainland china. it came pretty quickly too. It is machined properly but I had to clean it up first. There were multiple fine scratches on the taper which would not affect its use - just cosmetic. But there was one deeper scratch a bout 2 mm long that had a burr. That would have messed up my lathe headstock. I filed off the burr with a jeweler's file and buffed the whole adaptor with Flitz polish and green, then white scotchbrite pads. Now it works and looks like it should have from the factory. I had a number of Morse tape 1 bits that I wanted to use in a machine that uses morse taper 2. This was the only source for this adaptor, so I am glad for it. Too bad the quality control is lacking. At the same time I ordered a morse 2 drill chuck adaptor from another Ebay vendor in Brooklyn NY. Same price as this, and it came with a beautiful smooth blemish free finish.
Reginald O. Schulz
Reviewed in the United States on December 25, 2012
The product is what I expected, fits the existing #2 well and the #1 MT compoenents fit it well. I'm very pleased with it.
Recommended Products
