Your cart is empty.
Your cart is empty.Customer
Reviewed in the United States on January 7, 2025
Works as directed
Robert D. Brust
Reviewed in the United States on January 24, 2025
Well made, fit the purpose well. Deliverd on time.
Gean Espitia
Reviewed in the United States on February 6, 2024
Es un complemento para sitios donde no se puede usar la pulidora, ademas de ser mas facil de manejar ya que require menos fuerza en un taladro; esta hecho de un material resistente.
GSD
Reviewed in the United States on December 27, 2024
Works for diamond hole saw. Works as advertised.
Casey
Reviewed in Canada on December 26, 2024
Worked as described without failure. Used with a Vevor 4.25” x 14” diamond hole saw bit to drill through 7.5” of concrete foundation for a dryer termination.
Five0retired
Reviewed in the United States on May 2, 2023
I ordered this SHDIATOOL Adapter for Core Bits Conversion 5/8-Inch-11 to 3/8-Inch Hex Shank, for a bathroom project. I needed a hex shank for one of my porcelain core bits, I am using on my drill. The hex shank, in my opinion, could be a little bit longer, and I am not too crazy about the round base, I think a nut like base would be better, just for something to grab onto, and tighten the core bit into place.
gp
Reviewed in Canada on November 26, 2023
c'est correct
Todd
Reviewed in the United States on August 3, 2022
Fit's fine, but the slightest tweak of pressure will bend this out of straight causing anything you attach to it to wobble like made. Mine bent within the first 2 minute of use. And ended up going staight into the recycle bin. Don't waste your money!
Samuel M.
Reviewed in the United States on September 21, 2021
Sometimes "stainless steel" on amazon is actually very bad steel covered in a very thin coat of zinc (galvanized steel). The arbors/adapters I received were *NOT* galvanized. Seems like good steel. I had a wire brush wheel made to use with an angle grinder. I wanted to use the brush wheel with an electric drill instead. This adapter screwed in just fine.
Michelle Sheahan
Reviewed in the United States on May 24, 2021
The first purchase was for a 5/8-11 tri shaft and this would not fit in an extended. I needed to find, buy and use a hex shaft to fit my adapter. Drilled through 18 inches of brick with no issues. Worked like a charm
DanQc
Reviewed in Canada on October 20, 2021
screwed right on, no tread issues with mine, backing plate fits snugly, Good Quality. did not cause imbalance on my rotary tool, even with extra extension added.
Recommended Products
