Your cart is empty.
Your cart is empty. Material: PVC Heat Shrinkable;
Parameters: 200mm(7.9in) Wide, 3M(9.9ft) Length;
Thickness: 0.15mm;
Shrinking Rate: 48%(cross section)and 5%(longitudinal);
Shrinkage Temperature: 90-110(℃);
Size calculation formula: width + height (thickness) = size of PVC heat shrinkable tube;
Note: If it is a battery pack, it needs to add 20-30mm to the above formula before it can be installed.
Use Steps:
1. Cut to the length you want;
2. Prepare the heat shrink tube;
3. Put the battery or item into the heat shrink tube;
4. Use a heat gun to shrink;
Application: Used for 18650 21700 26650 lithium battery DIY battery pack and enhance electrical insulation.
Package Include:
200mm(7.9in) Wide, 3M(9.9ft) Length PVC Heat Shrink Wrap Tube;
Customer
Reviewed in the United States on January 9, 2025
Shrinks a ton. Both ways though. 5%? Shrink length? Nah. Maybe 15% to 20% buy extra and buy a fiberglass smoothing tool.
Flaughers
Reviewed in the United States on January 3, 2025
This works great for building my 18650 battery packs for solar
Luna
Reviewed in the United States on September 14, 2024
I ordered this wrap and it got here so quick. Excellent quality too.
Alan Lewis
Reviewed in the United States on July 11, 2024
Clean and neeat battery packs were my target. My goal was achieved!
Victor
Reviewed in the United States on May 6, 2024
PVC shrink wrap is thin but strong, You have to take caution while heating it as it can burn a whole easily. It has been great fory custom battery builds.
Vicki
Reviewed in the United States on February 5, 2024
This was for my son. An ebike enthusiast. He needed to wrap his ebike battery. This stuff worked easily and fast with a heat gun or blow dryer type thing on I and it shrunk up quickly and completely
Outside In
Reviewed in the United States on November 6, 2024
I built a battery pack and needed to cover it in heat shrink. The size in the description was perfect for my build, and would buy again if I have to build another pack the same size as before. Thick plastic, good quality, just make sure not to spend too much time in one area, or put too much heat because you are in a hurry LOL. I put a small hole in part of the shrink, but not a problem with the tubing, the problem was me getting in a hurry and using a little bit too much heat :). but you'll have this I guess - just remember to slow down a bit and back off a little on the heat as well, and this wrap will give you the result to desire and deserve.
Dan C.
Reviewed in the United States on December 11, 2023
Used this to encapsulate a 4x4 pressure treated wood post to set in concrete. Needed to create separation between the post and a metal post sleeve to prevent corrosion. Worked perfectly for this.
Recommended Products
