Your cart is empty.
Your cart is empty.Specification: Style: Unfinished for Electric Guitar DIY Style: Unfinish Orientation:Right or Left Up to You Installation Size: Width at Heel :2.22 inch / 56.50 mm (± 0.5 mm Deviation) Depth at Heel : 0.87 inch / 1.08 inch with Fingerboard (22.00mm / 27.50mm(±0.5mm Deviation)) Installation: Bolt On Head DIY Size: 4.72 x 6.69 x 0.59 inch / 120 x 170 x 15 mm Neck Size: Scale Length: 25.5 inch / 648 mm Number of Frets: 22 Width at Nut : 1.65 inch / 42 mm Width at 12th Fret: 2.05 inch / 52 mm Depth at 1st Fret: 0.87 inch / 22 mm Depth at 12th Fret: 0.87 inch / 22 mm Truss Rod Type: Double Style ,for 4 mm Allen Wrench Radius: 16 inch /406 mm Fret Wire Type : 2.4 mm Medium Jumbo Side Dot: 2mm Black Dot on the Left Side of The Neck Material: Material: Maple Origin from Canada Fingerboard: Maple Finish: Clear Satin Fret Wire: Cupronickel Mark Dot: Black Block Features: Made of Maple Wood Origin From Canada Which is More Sturdy and Resonance and Sustain Well Smooth Fingerboard Edge, No Hand Scratched Installed with Double Style Truss Rod for 4 mm Allen Wrench,So You Can Adjust to Loose or Tighten. Large Head Area for Your Guitar Design and You can Thinkfreely and Do What You Want Package Include: 1 x Unfinished Guitar Neck for DIY Note: guitar neck is hand craft and there may some tiny size error
Steveb
Reviewed in the United Kingdom on March 12, 2022
I was suprised with the quality for the price. I could not make it myself for that price.
BC
Reviewed in the United States on March 21, 2020
You cannot come close to building a neck for this price. I have not checked the frets but visually it seems straight. The radius is not consistent, needs fine tuning. I'm sure for most people this will work, but if your luthiers skills are basic, you may need to take this to someone for tweaking. BE AWARE that the headstock is STRAIGHT, (like a Fender) not angled like a Gibson, etc.
Michael Schulner
Reviewed in the United States on November 18, 2020
I like guitar necks with a two way truss rod. This is one way only ( straighten only ). The frets were not pressed with a fret press enough. The edges were also sharp. With some more tweaking I am a little closer to making this an exceptional guitar neck, but it has taken considerable effort. I ordered 2 of these ( one with a maple fretboard, and one with a rosewood fretboard). The rosewood neck is ok. I should have sent the maple fretboard one back, and re-ordered, but I needed it done right away. I am still relatively happy with the results though.
Boss Hogg
Reviewed in the United States on October 20, 2020
its good so far, really good, only issue is heavy satin poly finish would be better not to have that already on there, or less heavy, tba how it comes off, but its not hard like plastic it has a rubbery feel like it did not fully cure between coats...still cheaper than making my own neck even if i have to strip it
Brad D.
Reviewed in the United States on December 30, 2019
Very well made.
Recommended Products
$72.97
$ 31 .99 $31.99