Your cart is empty.
Your cart is empty.Product Description
We have our own factory, which can offer ODM & OEM service. The main series:
- PIPE FITTINGS
- HOSE BARB FITTINGS
- 45°FLARE FITTINGS
- COMPRESSION FITTINGS
- PUSH-IN FITTINGS
- DOT AIR BRAKE FITTINGS
Legines Brass Inverted Flare Fitting
Barstock Brake Line 90 Degree Male Elbow
- Adapts NPT male end to tube female end at a 90-degree angle.
- High quality CA360 brass with ductility at high temperatures, and low magnetic permeability has higher strength, higher hardness, corrosion resistance and stronger wear resistance than ordinary brass, meets the SAE standard.
- Typical application: For use with liquid petroleum (LP) and natural gas, refrigeration, hydraulic brake, trans-mission cooler lines, fuel, oil, air, lines, power steering.
- Material : CA360 / CA377
- Note : Not allowed by federal law to be installed for potable water use in the U.S.A.
Inverted 90 Degree Male Elbow
High quality material
Deep threads
Advantage
Inverted Flare Series
Our factory has more models for you to choose from.
Don Pierson
Reviewed in the United States on September 30, 2024
These came in a sealed bag as a pair but one was filthy inside requiring considerable cleaning to get it usable. The other was fine but not this one as shown in the photo.
DwKr
Reviewed in the United States on April 11, 2024
Good as advertised good value
Fernwood
Reviewed in the United States on August 17, 2023
Seems to be average quality and will probably work for intended purpose (external fuel pump on motor home) of connecting fuel tank drain to fuel pump. Hard to find 3/8" reverse flange street el fitting.
ACORN
Reviewed in the United States on June 1, 2023
I needed a fitting in a pinch... Amazon to the rescue... these fit and don't leak under high pressure.
sombody
Reviewed in the United States on July 5, 2021
Brass 90° for kodiak brake caliper
james noles
Reviewed in the United States on May 29, 2021
It fit and I repaired my air compressor.
Matthew
Reviewed in the United States on February 11, 2021
Used this to rebuild the brake lines on my 1954 GMC M211 military truck.
Robert M. Beyer
Reviewed in the United States on December 14, 2020
High quality brass fittings. Worked perfectly, absolutely nothing to complain about.
Recommended Products