Your cart is empty.
Your cart is empty.Product Description
How to use it?
The method of jointing the ends of the belt:
Step 1: To be heated with an alcohol lamp until it is hot enough to melt the end of the belting.
Step 2: Join the ends together until they cool.
Step 3: Trim off the extra material around the joint until the joint is the same diameter as the belt.
Application:
It is widely used in the transportation of packaging machines, printing machines, textile machines, transmission wheels, ceramic tiles, cement tiles, floor tiles, wooden products, food cans, newspaper prints, etc.
Reinaldo “sin llorar “
Reviewed in the United States on September 19, 2024
Definitely works, the system is been around forever . But you have to do it right, takes a few tries, yes a knife is the correct tool. Watch a few videos.
Al Amato
Reviewed in the United States on July 21, 2024
Easy to use. I used a soldering iron with an Exacto blade wired to the tip of the soldering iron to make a hot flat surface to “weld” the ends together.
CraftStitch
Reviewed in the United States on October 19, 2024
Perfect for sewing machines that require a V belt that is no longer made. To melt together, use a lighter. Hold both ends in one hand, touch the flame to one end, then the other, then repeat until they both look melty, then quickly push them together roll it between your fingers while pushing, to keep the diameter even. Allow to cool completely. This isn’t rocket science. Practice a few times on shorter pieces. It does melt together.
Zachary Liu
Reviewed in the United States on July 22, 2023
Darker than what appeared in the photo. Seems durable enough and worked for my application (Pulley).
Kevin
Reviewed in the United States on November 15, 2023
For a dryer it didn't last broke not too long after installing and running it
allan pechal
Reviewed in the United States on May 22, 2022
liked very much. used for a sewing machine belt.
RL007
Reviewed in the United States on November 15, 2021
I bought this to make a replacement belt for my 40 years old Emco Unimat 3 mini lathe and it worked great. I measured the belt length and cut this material about 10 mm short - perfectly flat and used my soldering iron with a blade attachment to melt both the ends and fused them. I sanded any extra material from the fused joint to remove any edge/bulge. I have been running my lathe for a week and it works perfect. Let’s see how long it lasts.
Mike
Reviewed in the United States on April 22, 2021
Used this to fix my push seeder belt which cost $20. This kit works just fine and if it breaks again I can just fix it by melting it together.
Recommended Products
$18.67
$ 7 .99 $7.99
$14.19
$ 6 .99 $6.99